兄弟hl2260drum灯闪烁怎么解决(Brother HL-2260DRUM Drum Light Flashing Troubleshooting Guide in 50 Words or Less)

Brother HL-2260DRUM Drum Light Flashing Troubleshooting Guide

If you have a Brother HL-2260DRUM printer and the drum light is flashing, it can be frustrating and may prevent you from being able to print. The drum light indicates that the drum unit is near the end of its life and needs to be replaced. Here are some troubleshooting steps to fix the issue:

Step 1: Reset the Drum Counter

The first thing you should try is resetting the drum counter. This will tell the printer that you have replaced the drum unit and the light should go off. To reset the drum counter, follow these steps:

Open the front cover of your printer.

Press and hold the "Go" button for about four seconds until all the LEDs light up.

Release the "Go" button.

Close the front cover of your printer.

The drum light should now turn off. If it doesn't, move on to the next step.

Step 2: Replace the Drum Unit

If resetting the drum counter doesn't work, you will need to replace the drum unit. Here's how to replace the drum unit:

Turn off your printer and unplug it from the power source.

Open the front cover of your printer.

Remove the drum unit and toner cartridge assembly.

Press the green lock lever down and take the toner cartridge out of the drum unit.

Unpack the new drum unit and remove the protective cover.

Insert the toner cartridge into the new drum unit and push it firmly until you hear it lock into place.

Insert the drum unit and toner cartridge assembly back into your printer.

Close the front cover and plug in your printer.

Turn on your printer.

The drum light should now turn off and you should be able to print normally. If the drum light still flashes, there might be an issue with the drum unit or your printer, and it's best to contact Brother or a printer technician for further assistance.

Conclusion

The drum light flashing on your Brother HL-2260DRUM printer indicates that the drum unit is near the end of its life and needs to be replaced. You can try resetting the drum counter first, but if the light continues to flash, replacing the drum unit is the only solution. By following the steps outlined above, you should be able to replace the drum unit and get your printer back up and running again.